Burda BRELD2200 Notice D'utilisation Et D'entretien page 10

M :
AINTENANCE
• To avoid risk of failures it is necessary to operate the
unit for a few hours every 6 months.
• If you have any question relevant your appliance,
call the local authorized distributor or the nearest
Service Centre. Every repairs should be carried on by
an authorized Service Centre and also ask always for
original spare parts.
• Before cleaning, be sure the appliance is
disconnected from the power supply and allowed
to cool. Never immerse the appliance in water or
any other liquid.
N :
ETWORK CONNECTION
• An overvoltage category III Combined Circuit
breaker and Residual Current Device (RCD) with rated
earth leakage operation not exceeding 30mA must be
fitted upstream on the supply line in order to have a
contact separation in all poles that provide a full
disconnection. The circuit breaker must have a
contact opening distance of at least 3 mm.
• The product is in class I and IP55, which is the
protection rate for the units to be used even outdoor.
For keeping the protection rate of the appliance, the
connection of the appliance with the power supply
must be done by means of a minimum IP55 system,
as per the standards HD 384 CENELEC for Europe, or
international IEC 60364-7 1988.
WARNING: The radiator must never be installed in
the upward or inward position; the heating surface
must always be positioned so that the heat is
directed downwards or outwards.
The heater must never be installed in the upward or
inward position, the heating surface must always be
positioned so that the heat is directed downwards or
outwards.
All manuals and user guides at all-guides.com
Before being used, the heater must
be fixed to the wall or to the ceiling by
means of the provided supports.
GB