Publicité
Les langues disponibles
Les langues disponibles
Water softener (Applicable models only)
Press Hygiene Plus until 'L0 - L5' is displayed. Select a water hardness level from Level 0
to Level 5 (default: L4), and then press Delay Start.
NOTE
If the water hardness level in your area is 0, you do not need to use dishwasher-specific
salt. However, you must set the water hardness setting for the dishwasher to 0.
Water hardness level
Level
°dH
0
<6
6-14
1
2
14-23
3
23-31
4
31-40
5
>40
Recommended using soft water for better results. Hard water contains impurities that can
reduce the washing performance. You will need to soften the water if the supplied water is
harder than 1.0 mmol/L (6 °d – German scale).
• To soften the water, you need dishwasher-specific salt and configuration of the water
hardness level according to your area. For more information about the water hardness
level in your area, contact your local water department.
• If the hardness level of the supplied water supply is unsteady, set the dishwasher to
the highest measurement. For example, if the water hardness reading ranges from
6.7 mmol/L to 9.0 mmol/L, set the dishwasher to 9.0 mmol/L.
• The dishwasher's default water hardness level is 4 (5.5-7.0 mmol/L). If this setting
matches the water hardness level in your area, you do not need to change it.
• Regeneration will be operated in dry phase with an additional 2.3-2.7 L of water being
used and 22-27 minutes taken for the cycle. The energy used my be increase however
this should be by an insignificant amount.
DD68-00271C-01_IB_DW8700B_EN.indd 39
DD68-00271C-01_IB_DW8700B_EN.indd 39
Water hardness
°TH
mmol/L
Range
<10
<1.0
No recycle
10-25
1-2.5
1/8
25-40
2.5-4.0
1/5
40-55
4.0-5.5
1/3
55-70
5.5-7.0
1/2
>70
>7.0
1/1
Regeneration
softening/washing
Salt injection
cycle (ECO program)
No
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
Yes
Yes
English
39
2024-07-16( )
2024-07-16( )
2:59:09
2:59:09
Publicité
