Publicité
Les langues disponibles
Les langues disponibles
Automatic power-off
(POWER MANAGEMENT)
This display is equipped with [POWER MGT.] function,
which allows the unit to automatically switch to standby
mode when no sync signal is detected.
(A warning message is displayed before this function
operates.)
Note
Always turn off the Plasma Display's main power switch when
not using the display for extended periods of time.
Remote control unit
DISPLAY
STANDBY/ON
MENU
/ SET
MENU SET
Main unit operating panel
1
Press the MENU button to display the menu
screen.
MENU
PICTURE
SCREEN
C O N T R A S T
B R I G H T N E S S
H . E N H A N C E
V. E N H A N C E
P I C T U R E R E S E T
SET
ENTER
All manuals and user guides at all-guides.com
INPUT
MENU
2/3
SET
INPUT SCREEN SIZE
– VOL +
2/3
INPUT
INPUT1
SETUP
OPTION
0
:
0
:
0
:
:
0
MENU
EXIT
2
Use the 2/3 buttons to select [SETUP].
MENU
PICTURE
SCREEN
P O W E R M G T.
S I G N A L F O R M AT
SET
CHANGE
3
Press the SET button to confirm selection of
[POWER MGT.].
The factory default setting is [OFF].
Each time the button is pressed, the setting alternates
as follows:
3 OFF
ON 2
÷ OFF ..... The display will continue in operating mode,
regardless of the presence/absence of an
input sync signal.
÷ ON ....... If a sync signal is not detected, a warning
message is first displayed for 8 seconds,
after which the display automatically enters
the standby mode, and the STANDBY/ON
indicator flashes green. If a sync signal is
input again later, the Plasma Display
automatically returns to normal operating
mode (*1).
*1. Except when input signal is G ON SYNC or
composite SYNC
4
When the setup is finished, press the MENU
button to exit the menu screen.
Note
The [POWER MGT.] function must be set individually for each
input (INPUT1 or INPUT2).
To return to operating mode:
To return to normal operation from the [POWER MGT.]
function's standby mode, either operate your computer,
or press the INPUT button.
Operation
INPUT1
SETUP
OPTION
: O F F
MENU
EXIT
23
En
Publicité
