Morgan Olson C250 Guide De L'opérateur page 9

Cab Features
POWER WINDOWS
Press the switch to lower the windows, and pull the
switch to raise the windows. The power windows only
function when the corresponding door is fully closed.
ONE-TOUCH OPEN
Long press the window switch and release it to
automatically fully lower the window. Press again
or lift it to stop the window.
The window does not have bounce-back, and will
not reverse if it detects an obstacle when closing. Take care when
closing the windows to avoid personal injury or damage to your
vehicle.
16
Page 16 Page 16
Page 13
PARKING BRAKE
To engage the parking brake, pull on the parking
brake switch. To disengage the parking brake,
push the parking brake switch.
Pressing the accelerator pedal when the vehicle
is in drive (D) will automatically turn off the
parking brake.
NOTE: A light on the instrument
cluster will indicate when the parking
brake is activated. The indicator may
vary depending on the region.
Neutral Mechanical Override
The C250 features a manual transmission override,
mounted to a leg below the center stack of the instrument
panel. This can be used to shift the transmission into
neutral without vehicle power if the vehicle needs to be
towed.
ACTIVATING THE NEUTRAL MECHANICAL
OVERRIDE
When doing this procedure, you need
to take the transmission out of park (P) which means
your vehicle can roll freely. To avoid unwanted vehicle
movement, always fully apply the parking brake prior to
doing this procedure. Use wheel chocks if appropriate.
Do not activate the override lever until you are in the
driver's seat.
1. Apply the parking brake.
2. Switch the ignition on, but not the engine.
3. From the driver's seat, fully apply the brake pedal and
hold. Do not release. Pull the override straight out toward
the passenger seat until engaged. If done correctly, a
message will appear in the instrument cluster.
Note: Your vehicle remains in neutral (N) for emergency
towing purposes and is free to roll.
4. Turn off the ignition.
5. Once safe to do so, and there is no risk that your vehicle
will roll, disconnect the negative (black) battery cable from
the battery.
C250 CAB FEATURES
RETURNING YOUR VEHICLE
TO NORMAL MODE
1. Once safe to do so, reconnect the negative (black)
battery cable to the battery.
2. Apply the parking brake.
3. Once in the driver seat, fully apply the brake pedal and
hold, do not release. Using the tether, pull the handle
towards the passenger seat until you hit a hard stop.
4. Pull the lever toward the floor until it hits a hard stop,
before returning to the stowed position.
Note: Maintain tension on the strap until the lever reaches
the stowed position.
5. With your foot fully applied on the brake pedal, start
your vehicle. Confirm that your vehicle is in the park (P)
position and that the instrument cluster indicates park (P).
Page 14 Page 17