Morgan Olson C250 Guide De L'opérateur page 22

HEADLIGHT AIMING
(CONT.)
6. Place the aimers with the adaptors onto the headlights. If the adjustment rods do not touch the aiming pads, use
the extension studs to provide proper reach for the vacuum cup, or remove one or both of the extension studs. If the
articulating vacuum cap does not touch the lens of the headlights, then add one or both of the extension studs to the
vacuum cup assembly.
6.
Page 39 Page 42
REMOVE / ADD
EXTENSION STUD(S)
7a. Attach each aimer to headlight by pushing the piston handle forward, then engaging the rubber
suction cup.
7a.
LEVEL BUBBLE
VERTICAL
DIAL
HORIZONTAL
DIAL
VIEWING
PORT
SIGHT OPENINGS
(MUST FACE EACH OTHER)
UNIT B MUST BE USED
ON CURB SIDE
7b. Once attached, immediately pull back
the piston handle until it locks in place.
C250 HEADLIGHTS
LEVEL BUBBLE
VERTICAL
DIAL
HORIZONTAL
DIAL
VIEWING
PORT
UNIT A MUST BE USED
ON ROAD SIDE
BOTTOM VIEW
7b.
HANDLE FORWARD TO ENGAGE CUP
HANDLE BACK
UNTIL LOCKED
Page 40 Page 43