Publicité
Les langues disponibles
Les langues disponibles
Headlights
HEADLIGHT AIMING
Your headlights are equipped with aim pads and are designed to be aimed mechanically. We recommend getting your
workplace ready before aiming your headlights. The vehicle should be parked on a flat, level surface, and is empty,
clean of mud and ice, and all tires are properly inflated. Check and clean the headlights and aiming pads. Rock the
vehicle to equalize the springs, and check them for sag or broken leaves.
1. Attach the 7" circular adaptor to each aimer.
Adaptors will easily snap into place when properly
positioned.
1.
2. Steel inserts are molded into position in the adaptor
to ensure accuracy. These inserts must be in contact
with three aiming pads on the lamps when the aimer is
properly positioned.
2.
ADAPTOR INSERTS
LAMP GUIDE POINTS
Page 37
Page 40
3. Select the Universal Adaptor that matches the aiming
pads pattern on the lens of the headlight.
3.
LARGE UNIVERSAL ADAPTOR
7"
SMALL UNIVERSAL ADAPTOR
4. Align the selected adaptor to the aiming pads. Move
the adjustment rod for each pad until it agrees with the
number located next to the pad as shown below. On some
lamps, the numbers are located along the lower edge or
the vertical edge of the lens.
4.
17
ADJUSTMENT SETTINGS
FOUND ON EACH HEADLIGHT
SHOULD BE USED WHEN
SETTING THE ADJUSTMENT
RODS.
INBOARD PAD SETTING IS 0
11
0
C250
HEADLIGHTS
5. Adjust the rods to the required number position.
To adjust, turn the rods to the neutral position, and
slide in or out to the proper setting, then turn the rod
clockwise to lock in an odd number, and
counter-clockwise to lock in an even number.
5.
NEUTRAL POSITION
5.
EVEN NUMBER
LOCK
5.
LOCK
ODD NUMBER
Page 38
Page 41
Publicité
