Morgan Olson C250 Guide De L'opérateur page 23

TO SET HEADLIGHT HORIZONTAL AIM
1. Set the horizontal aim knob to zero, and
check that the split image target lines are
visible in the horizontal aim port hole. If
necessary, rotate each aimer slightly to locate
the target.
2. Turn the horizontal adjusting screw at side
of headlight until the split image of target line
appears in mirrors as one solid line. To
remove "backlash", make a final adjustment
by turning the screw in a clockwise direction.
2.
3. Repeat these steps with the
HORIZONTAL
opposite side aimer and
ADJUSTING
headlight. SCREW
Page 41 Page 44
B4A AIMER
1.
HORIZONTAL AIM PORT HOLE VERTICAL AIM KNOB
HORIZONTAL AIM KNOB VERTICAL AIM VIAL
UNIT
IDENTIFICATION FLOOR LEVEL DIAL
FLOOR SLOPE
PORT HOLE
VACUUM RELEASE BUTTON
FLOOR SLOPE LEVEL VIAL
PISTON HANDLE
2.
SPLIT IMAGE
SPLIT IMAGE
ALIGNED
NOT ALIGNED
TO SET HEADLIGHT VERTICAL AIM
1. Set the vertical aim knob to zero.
2. Turn vertical adjusting screw at the top of the
headlight until the level bubble is centered
between the lines. To remove "backlash", make
final adjustment by turning screw in a clockwise
direction.
3. Repeat these steps with the opposite side aimer
and headlight.
4. Recheck target alignment on both aimers and
readjust horizontal aim if necessary.
5. Remove aimer by holding aimer securely and
pressing "Vacuum Release" button located on the
piston handle.
2.
VERTICAL
ADJUSTING
SCREW
C250 HEADLIGHTS
1.
VERTICAL
AIM KNOB
2.
Page 42 Page 45