Parkside PSSFS 3 A2 Instructions D'utilisation Et Consignes De Sécurité page 16

8 . Change the position (height and side angle) of the satellite antenna until the display
needle shows the maximum value on the display scale
[ 6 ]
9 . Rotate the control knob
with the middle part of the display scale
NOTE: It may be necessary to repeat the setting process several times while
adjusting the satellite antenna .
10 . Finely adjust the satellite antenna to achieve the highest value on the display
needle and an acoustic signal .
[ 6 ]
11 . Once the satellite antenna is optimally set, fix it in place (observe the satellite
antenna manufacturer's instructions) .
12 . Switch off the satellite receiver . Disconnect the product from the antenna .
m ATTENTION! Never disconnect the product from the antenna before switching off
the satellite receiver . Risk of short circuit product damage .
13 . Connect the LNB with the satellite receiver . Restore the original cabling . Check the
picture on the TV and whether the desired satellite is accessed .
NOTE: It may be necessary to repeat the setting process several times .
14 GB/IE/NI
counter‑clockwise until the display needle
3 ] [
1 ] [
.
[ 1 ]
.
is aligned
6 ] [