Publicité
Les langues disponibles
Les langues disponibles
Hot water:
Swing the handle
to the left.
23
Cold water:
Swing the handle
to the right.
23
Maintenance and cleaning
Maintaining and
cleaning the tap
Please note that sanitary taps require special care
and attention. Therefore, please follow the instructions:
When cleaning, never use petrol, solvents,
aggressive cleansers or hard cleaning brushes
etc. These could damage the surface of the
product.
Dry your fitting with a cloth after every use to
prevent any lime deposits.
Clean the product with a damp, soft cloth and
a mild cleaning agent if required.
Non-observance of the above care advice can be
expected to result in damage to the surfaces of the
product. This will inevitably invalidate the guarantee.
Replacing the LED insert
If the LED lamps fail to light, the LED insert may be
replaced.
LED life: approx. 10,000 operating hours.
A new LED insert can be obtained from the specified
service address.
To do so, follow these steps:
Unscrew the fitting mixer
body (see Fig. D1), which requires a cross-tip
screwdriver.
Unscrew the LED cover from the fitting body
using the socket head wrench
Remove the plastic LED insert (see Fig. D3–D4)
using the LED installation wrench
Install the new LED insert, the LED cover and
the fitting mixer
1
Fig. D5‒D7).
from the fitting
1
(see Fig. D2).
21
.
22
similar to disassembly (see
Operation / Maintenance and cleaning
Replacing the screen
If the screen inside the LED cover is severely clogged
it must be cleaned or replaced.
To do so, follow these steps:
Unscrew the fitting mixer
body (see Fig. D1), which requires a cross-tip
screwdriver.
Unscrew the LED cover from the fitting body
using the socket head wrench
Push the screen out of the LED cover from the
outside, using a flat object (see Fig. E1).
CAUTION RISK OF INJURY! The outer
edge of the screen fabric may be pointy.
Remove any limescale deposits or foreign bodies.
Replace the screen if severely clogged or dam-
aged. A new screen can be obtained from the
specified service address.
Press the cleaned / new screen into the LED cover
from the inside (see Fig. E2).
Note: be sure the screen is properly seated in
the LED cover.
Install the LED cover and the fitting mixer
similar to disassembly (see Fig. D6‒D7).
Replacing the cartridge
A cartridge
is a wear part that needs replacing
28
according to the hardness and / or degree of con-
tamination of the water. This becomes evident
when the handle
becomes difficult to move. A
23
new cartridges
can be obtained from the listed
28
service office.
Note: this step requires an open-end spanner
SW 25 mm or fitting pliers.
Proceed as follows to replace the cartridge
Shut off the main water supply. Allow any
remaining water in the pipework to drain.
Remove the hot / cold plaque
the handle
to the highest position and in-
23
serting a flat object between the edge of the
hot / cold plaque
handle
.
23
from the fitting
1
(see Fig. D2).
21
28
by adjusting
25
and the outside of the
25
GB/IE
1
:
17
Publicité
