Publicité
Les langues disponibles
Les langues disponibles
Introduction
LED Basin Mixer Tap
Introduction
Congratulations on the purchase of your
new product. You have selected a high
quality product. The assembly and oper-
ating instructions are part of this product. Please
carefully read these assembly instructions / instruc-
tions for use before use and observe all instructions.
These assembly instructions and instructions for use
contains important assembly, set-up and care infor-
mation. Please retain these assembly instructions /
instructions for use and hand them on to any future
owner.
Intended use
The product is only designed to regulate the hot and
cold water flow. It is only intended to be installed in
washbasins. Suitable for use with all pressure-resist-
ant hot water systems such as central heating, con-
tinuous-flow water heater, pressure boiler etc. This
product is not suitable for low pressure water heat-
ers or pressure-free small storage reservoirs, e.g.
wood- or coal-burning domestic hot water heaters,
oil or gas-fired hot water heaters, or open electri-
cally heated cylinders. When in doubt please con-
sult a plumber or heating specialist. Any use not
specified or product modification is prohibited and
will result in damage. Any form of use other than the
stipulated intended purpose can cause danger to life
and cause injury. The product is for private use only
and is not intended for medical or commercial use.
The manufacturer accepts no responsibility if the in-
tended purpose of this unit is not adhered to.
Parts description
Fitting
1
Fitting base seal
2
Pop-up pull rod (part 1)
3
Screw coupling between the two pull-rods
4
Pop-up pull rod (part 2)
5
14 GB/IE
C sealing washer
6
C metal washer
7
2 Threaded bolts
8
2 Securing nuts
9
2 flexible connecting hoses
10
Pop-up joint
11
Pop-up knee-joint bar
12
Pop-up drain plug
13
Pop-up seal (upper)
14
Pop-up flange (upper)
15
Pop-up seal (lower)
16
Pop-up flange (lower)
17
Pop-up screw thread
18
Pop-up plastic nut
19
2 Union nuts with seal
20
Socket head wrench
21
LED installation spanner
22
Handle
23
Locking screw
24
Warm- / cold plaque
25
Cartridge covering ring
26
Cartridge locknut
27
Cartridge
28
Technical Data
Connections:
Minimum flow pressure: 1.5 bar
LED light:
Temperature sensor
tolerance:
Scope of delivery
1 Washbasin fitting
1
1 Fastening kit (
,
2
6
2 Flexible connection hoses with seal 3/8" (
1 Pop-up pull rod with screw joint (
1 Pop-up coupler
11
1 Pop-up pivot rod
12
1 Pop-up (
–
)
13
19
G 3/8"
approx. < 33°C blue,
approx. 33–39°C green,
approx. > 39°C red,
approx. > 53°C flashing
red
+/- 2°C
–
)
9
,
10
20
–
)
3
5
)
Publicité
