Publicité
Les langues disponibles
Les langues disponibles
1 Socket head wrench
1 LED installation spanner
1 Instructions for assembly / operation
Safety information
LIFE AND RISK OF ACCIDENTS
FOR INFANTS AND CHILDREN!
Never leave children unattended with the pack-
aging material. Danger of suffocation. Keep this
product well away from children. This product
is not a toy.
BEWARE OF ELECTRIC SHOCK!
Leaking or water discharge can lead
to life-threatening danger due to
electric shock. Carefully check that all connec-
tions are watertight. Also ensure that all wires
of electric appliances are correct and have
been securely installed.
CAUTION! RISK OF INJURY! Please ensure
that no parts are damaged and that all parts
are correctly assembled. Incorrect assembly
could lead to injury. Please note that washers
and gaskets are wear parts and therefore will
need to be replaced from time to time. Dam-
aged parts could impact safety and function.
CAUTION! DAMAGE TO THE ARTICLE!
Please have all installations performed by skilled
individuals.
Be sure all seals are correctly seated.
SCALDING RISK! When adjusting the hot
water temperature be sure the water tempera-
ture is not too high.
CAUTION! Be careful not to revere the hot /
cold water plaque
25
left = red (hot),
right = blue (cold).
Please note all seals are wear items and will
therefore need to be replaced over time.
Any leakage or sudden escape of water can
cause considerable damage to buildings and
property. All connections must therefore be
checked carefully to ensure that they are tight.
21
22
DANGER TO
. The correct placement is:
Introduction / Safety information / Installation
Familiarise yourself prior to installation with all
local conditions, e.g. water connections and
shut-off device.
The product is only suitable for use in rooms
with a temperature above 0 °C.
Installation
Note: Familiarise yourself with the product prior to
assembly. Carefully read the following assembly
instructions and safety advice. In the event of incor-
rect installation, all warranty claims – particularly
in relation to subsequent damage – are excluded.
CAUTION! Before you start installation turn
off the water supply at the mains. Otherwise
injuries and / or property damage may occur.
CAUTION! Do not twist the connection hoses
or place them under tension.
10
Note: this step requires a cross-tip screwdriver,
a slotted screwdriver and a spanner SW 10 mm.
Follow these steps:
Place the fitting base seal
on the base of the fitting
Screw the two flexible connection hoses
hand tight into the designated female threads
inside the fitting body
Note: the two flexible connection hoses
are identical.
The flexible connection hose
into the left borehole on the fitting body will be
the hot water hose, the flexible connection
hose
being screwed into the right borehole
10
will be the cold water hose.
CAUTION! Be sure to only tighten the flexible
connection hoses
Do not use pliers or a wrench. Otherwise the
product could be damaged.
Remove the securing nuts
bolts
, then using a slotted screwdriver
8
screw the thread bolts
designated female threads on the fitting
(see Fig. C2).
Unscrew the handle from part 1 of the pop-up
pull rod
3
the bottom up so the female thread on the
inside the groove
2
.
1
(see Fig. C1).
1
being screwed
10
hand tight (see Fig. B).
10
from the thread
9
all the way into the
8
and insert it into the fitting
10
10
1
from
1
GB/IE
15
Publicité
