Publicité
Les langues disponibles
Les langues disponibles
Connection to power supply
The socket should be connected in compliance with the relevant standard, to a dedicated
omnipolar circuit breaker. 30 A minimum supply.
Mains
220-240V~ 50/60Hz
* calculated with the simultaneous factor following standard EN 60 335-2-6
Caution! Ensure that you correctly attach the wires and the bridges and tighten the screws
properly.
We cannot be held responsible for any incident resulting from incorrect connection or
which could arise from the use of an appliance which has not been earthed or has been
We apologise for any inconvenience caused by minor inconsistencies in these instructions, which
may occur as a result of product improvement and development.
Connection
Cable diameter
1 Phase + N
3 x 1,5 mm
equipped with a faulty earth connection.
1 1
Cable
H 05 VV - F
2
H 05 RR - F
40
Protection calibre
16 A *
Publicité
