Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
Advice for the installer
IMPORTANT
Appliance installation and maintenance must only be carried out by QUALIFIED TECHNICIANS
and in compliance with the local safety standards.
Failure to observe this rule will invalidate the warranty
Installation
How to fit the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
His installation has to be done carefully, in conformity of the following drawing.
Fitting - installing:
• Cut a hole in the worktop of the dimension shown in the diagram below. Ensure that there
is a distance of 50 mm between the hob and the wall or sides. The worktop should be at
least 30 mm thick and of heat-resistant material.
• The hobs are classified as "Y" class for heat protection. Ideally the hob should be installed
with plenty of space on either side. There may be a wall at the rear and tall units or a wall
at one side. On the other side, however, no unit or divider must stand higher than
the hob.
• The piece of furniture or the support in which the hob is to be fitted, as well as the edges of
furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
• The mural rods of edge must be heat-resisting.
• Not to install the hob to the top of a not ventilated oven or a dishwasher.
• To guarantee under the bottom of the hob casing a space of 20 mm to ensure a good air
circulation of the electronic device.
Stick the gasket (2) two millimeters
from the external edge of the glass,
after removing the protection sheet (3).
37
Publicité
