Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL CONNECTION
Installation must be carried out according to the manufacturer's instructions. Incorrect installation
may cause harm and damage to people, animals or property, for which the manufacturer accepts
no responsibility.
Before carrying out any work on the electrical section of the appliance, it must be disconnected
from the mains.
Connection to a good earth wiring system is absolutely essential.
The manufacturer accepts no responsibility for any inconvenience caused by failure to comply
with this rule.
The hob must be installed by a qualified electrician in line with all electrical and installation
requirements published by the Institute of Electrical Engineers. We recommend that the
appliance is connected by a qualified electrician, who is a member of the N.l.C.E l C. and who will
comply with the l.E.E. and local regulations.
Before carrying out the connection to the power supply, the voltage rating of the appliance
(stamped on the appliance identification plate) must be checked for correspondence to the
available mains supply voltage, and the mains electric wiring should be capable of handling the
appliance's power rating (also indicated on the identification plate).
This appliance must be connected by a competent person, using fixed wiring via a DOUBLE
POLE SWITCHED FUSED SPUR OUTLET (with 3 mm minimum distance between the contacts).
A double pole switch must be provided no further than 2 metres from the appliance to the
electrical supply. All supply current and earth conductors must be able to withstand an ambient
temperature of 75°C.
After having installed the appliance, the power switch must always be in a accessible position.
Use a 35 AMP fuse
The wires in the mains lead are coloured in accordance with the following code:
Green & Yellow = Earth
As the colours of the wires in the mains lead for the appliance, may not correspond with the
coloured markings identifying the terminals in your spur box, proceed as follows:
1)
The wire which is coloured green and yellow must be connected to the terminal marked E
(Earth) or Green coloured.
2)
The wire which is coloured blue must be connected to the terminal marked N (Neutral), or
coloured Grey.
3)
The wire which is coloured brown must be connected to the terminal marked L (Live), or
coloured Black.
Cautions
• The induction hob must be installed by a properly qualified person. Never try to install the
appliance yourself.
• The induction hob must not be installed above refrigerators, freezers, dishwashers or
tumble dryers. Install the induction hob away from heat sources such as ovens or direct
sunlight.
• The induction hob should be installed so that optimum radiation of heat is possible.
• The wall and the area above the hob should be able to withstand heat.
• To avoid any damage, the sandwich layer and adhesive should be heat-resistant.
Blue = Neutral
39
Brown = Live
Publicité
