fadini Elpro 27 HP Notice D'instructions page 24

Elpro 27 HP
GB
230 V
ELECTRICAL CONNECTIONS ON SWINGING GATE MODE - dip-switch - B n° 1 = OFF
Accessory
Power connections
to Pulin 3 LEDs:
24 Vdc - 5 W output:
Limit switches:
Traffic lights plug-in card (optional - Item No. 7282L):
The power supply of this card is independent from that of the control board:
230 V - 50 Hz with an output of 100 W at 230 V each lamp.
Logic of operation:
- GREEN light = driveway OPEN
- RED light = driveway CLOSED
- YELLOW light = it switches on before light changes from green to red
Note: in pedestrians mode the traffic light is always RED.
Dip-switch - A
4 = ON Pre-flashing enabled: traffic lights red - yellow - green
4 = OFF Pre-flashing disabled: traffic lights red - green
6 = ON Limit switches installed
6 = OFF Limit switches linked out (functioning by time setting)
Dip-Switch - B
3 = ON Pre-flashing time prolonged by about 2 seconds
(yellow light up to 3 seconds)
3 = OFF Standard time as factory-preset
Functioning with 2 lamps (red and green):
Dip-switch - A 4 = OFF
Dip-switch - A 6 = adjust setting depending on whether the limit switches
Dip-Switch - B 3 = OFF
UNIVERSAL ELECTRONIC CONTROL BOX
SINGLE-PHASE 230 V - 50/60 Hz
Electrical connections
3 28 27 26
OUTPUT
29 30
24 Vdc - 5 W max
IMPORTANT:
if no limit switches are involved, link
out terminals 30 - 31 - 32 - 33 - 34.
Limit switches (L-sw.) must have
normally closed contacts.
are used or not in the installation
Terminals for the
connections of the LEDs
of the push buttons
Pulin 3
M1 M2
30 31 32 33 34
24
LED indication of functions
L30 ON = OFF on engaging L.sw. Opening M1
L31 ON = OFF on engaging L.sw. Closing M1
L33 ON = OFF on engaging L.sw. Opening M2
L34 ON = OFF on engaging L.sw. Closing M2
RED
YELLOW
GREEN
63 64 65 66 60 61
1 A fuse
Red
Yellow
Green
(Optional:
traffic lights plug-in card
for 230 V lamps)
item 7282L