Operation - Delta 14-651 Type III Manuel D'utilisation

OPERATIONAL CONTROLS AND ADJUSTMENTS
HOW TO START AND STOP THE MACHINE
The power switch is located on the left side of the Mortiser.
To turn the Mortiser "ON", press the green start button (A) Fig.
22. To stop the Mortiser, push the red button (B).
HOW TO LOCK THE SWITCH IN THE "OFF" POSITION
IMPORTANT: When the machine is not in use, the switch
should be locked
in the "OFF" position to prevent unauthor-
using a padlock (A) Fig. 23 with a 3/16" diameter
ized use,
shackle.
HOW TO ADJUST THE DEPTH STOP ROD
The depth stop rod (A) Fig. 24 limits the depth of the chisel.
To adjust the depth stop rod (A), loosen the lever (C)
and lower the head. When the head is at the desired
location, lower the depth stop rod (A) until it contacts the top
of the column (D) and tighten the lever (C).
HOW TO ADJUST THE FENCE
You can move the fence (A) Fig. 25 in or out by loosen-
ing the lock handles (B), and rotating the fence rack
handle (C). Tighten the handles (B) after the move.
NOTE: The levers (B) are spring-loaded and can be
repositioned. Pull out on the lever and reposition it on
the serrated nut located underneath the lever.
Your fence comes adjusted from the factory. If the fence
feels loose during adjustment, adjust the two set screws
(D) Fig. 25 snugly against the Fence rack.

OPERATION

11
A
B
Fig. 23
D
A
B
D
Fig. 25
Fig. 22
A
A
C
Fig. 24
C
D