Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATIONAL CONTROLS ANd AdJUSTMENTS
To reduce the risk of injury, do not
operate the machine with any dust intake holes
uncovered. The rotating fan, located inside the
blower housing, is accessible through the dust intake
port and can be hazardous. Always wear proper
apparel. do not wear jewelry. Keep your fingers and
all foreign objects out of the dust intake port. Follow
the safety rules in this manual.
STARTINg ANd STOPPINg THE dUST
COLLECTOR
The "ON/OFF" switch is located on the side of the motor.
To turn the machine "ON", push the start button (A)
Fig. 21. To turn the machine "OFF", push stop button (B).
Make sure that the switch is in the
"OFF" position before plugging in the power cord.
In the event of a power failure, move the switch to
the "OFF" position. An accidental start-up can cause
injury.
LOCKINg THE SWITCH IN THE "OFF"
POSITION
IMPORTANT: When the machine is not in use, the
switch should be locked in the "OFF" position to prevent
unauthorized use, using a padlock (C) Fig. 22 with a
3/16" (4.8 mm) diameter shackle.
FIRE HAzARd. When using this dust collector, do not pick up anything that is burning, smoldering,
or smoking (matches, cigarettes, or hot ashes).
ExPLOSION HAzARd. do not use this unit to vacuum combustible explosive materials (coal, grain,
or other finely-divided combustible material).
HEALTH HAzARd. do not use this unit to vacuum hazardous, toxic, or carcinogenic materials
(asbestos, pesticide, or lead-based paint debris).
CIRCUIT BREAKER
Your dust collector motor is supplied with a resettable circuit breaker. If the motor shuts off or fails to start due to an
overload condition, turn the dust collector switch "OFF," let the motor cool three to five minutes, and push the reset
button (D) Fig. 22, on the circuit breaker to reset the breaker. The motor can then be turned on again in the usual
manner. If the overload continues to trip, visit our website at www.deltamachinery.com for a list of service centers or
call the DELTA Machinery help line at (800) 223-7278 (In Canada call (800) 463-3582).
For assistance with your machine, visit our website at www.deltaportercable.com for a list of service centers or call the
DELTA Machinery help line at (800) 223-7278 (In Canada call (800) 463-3582).
OPERATION
TROUBLESHOOTINg
12 -
English
Fig. 21
A
B
Fig. 22
D
A
C
Publicité
Table des Matières
Dépannage
