Operation - Delta 23-710 Manuel D'utilisation

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and remov-
ing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.
OPERATIONAL CONTROLS AND ADJUSTMENTS
USINg TOOL AND CHISEL HOLDER
The tool and chisel holder is supplied as standard
equip ment with your sharpening center and is ideal for
sharp en ing wood chisels, plane irons, some lathe turn-
ing tools, etc. To use the tool and chisel holder, proceed
as follows.
1. Loosen the two clamp knobs (A) Figs. 25, 26 and 27,
and insert the tool or chisel between the clamp as
shown, making sure the edge of the tool or chisel
is against the inside of the protractor gage (B). Fig.
25 illustrates a plane iron; Fig. 26 illustrates a wood
chisel; and Fig. 27 illustrates a lathe turning tool in-
serted between the clamp of the tool and chisel
holder. Then tighten the two clamp knobs (A). Adjust
the protractor gage (B) so that the cutting edge of
the tool to be sharpened is the correct angle for the
grinding wheel. Loosen screw (C) Fig. 27, and adjust
the protractor gage (B) as shown. Tighten screw (C)
after angle is obtained.
2. Place the complete tool and chisel holder assembly
(D) Fig. 28, on the tool rest base (E) as shown. Ad-
justment of the tool rest is explained in section "AS-
SEMBLING AND ADJUSTING TOOL AND CHISEL
HOLDER."
3. Figure 29, illustrates a plane iron being sharpened
using the tool and chisel holder (D) supplied with the
machine.
D
All manuals and user guides at all-guides.com

OPERATION

Fig. 29
12
A
B
Fig. 25
A
B
Fig. 26
A
C
B
Fig. 27
D
Fig. 28
E