Troubleshooting; Maintenance - Delta 14-651 Type III Manuel D'utilisation

HOW TO ROTATE THE COLUMN 180 DEGREES
The column (A) Fig. 30 can be rotated 180 degrees for special cuts. To rotate the column, remove the four screws, two
of which are shown at (B), rotate the column (A) 180 degrees, and replace the four screws (B).
You must secure the base to a supporting surface.
HOW TO USE BITS WITH EXTRA LONG SHANKS
When using bits with extra long shanks, remove the extension (A) Fig. 30. Insert a screwdriver into the slot (B) Fig. 30
in the end of the armature shaft on top of the motor (B) Fig. 32. Use a chuck key to unscrew and remove the chuck
(C) Fig. 31 and extension (A). Remove the extension (A) from the chuck (C) and replace the chuck (C). You can also
use the chisel spacer. Place the chisel spacer (D) Fig. 33 on the chisel shank (F) and insert the chisel into the chisel
holder. Tighten the chisel holder securely.
B
For assistance with your machine, visit our website at www.DeltaMachinery.com for a list of service centers or call
the DELTA® Power Equipment Corporation help line at 1-800-223-7278.
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the
FAILURE TO START
Should your machine fail to start, check to make sure the prongs on the cord plug are making good contact in the
outlet. Also, check for blown fuses or open circuit breakers in the line.
LUBRICATION & RUST PROTECTION
Apply household floor paste wax to the machine table, extension table or other work surface weekly. Or use a commercially
available protective product designed for this purpose. Follow the manufacturer's instructions for use and safety.
To clean cast iron tables of rust, you will need the following materials: a sheet of medium Scotch-Brite™ Blending Hand
Pad, a can of WD-40 and a can of degreaser. Apply the WD-40 and polish the table surface with the Scotch-Brite pad. ®
Degrease the table, then apply the protective product as described above.
A
Fig. 30
B
Fig. 32

TROUBLESHOOTING

MAINTENANCE

13
C
F
D
A
Fig. 31
Fig. 33