Delta 14-651 Type III Manuel D'utilisation page 12

HOW TO ADJUST THE HOLD-DOWN
The hold-down (C) Fig. 26 prevents the work piece
(E) from lifting as the chisel rises out of the hole. To adjust
the hold-down, loosen the handle (F), position the hold-
down so that it just touches the top of the work piece (E),
then tighten the handle. You can turn the hold-down (C)
upside down to accommodate thicker work pieces.
HOW TO ADJUST THE CHISEL PARALLEL TO THE WORK PIECE
You can adjust the chisel (A) Fig. 27 parallel to the work piece by loosening the screw (B) and rotating the chisel until
the back surface of the chisel is touching the work piece. Tighten the screw (B).
HOW TO ADJUST THE SLIDING FIT BETWEEN THE HEAD AND THE COLUMN
A dovetail gib (A) Fig. 28 ensures a good sliding fit between the head and the column. Make the adjust-
ment by loosening the two screws (B) and turning the adjusting screws (C). Tighten the two screws (B).
NOTE: The adjustment is correct when no side movement between the gib and the column is evident. Adjust the gib
so that it is not so tight as to restrict the sliding movement or so loose that it affects accuracy.
A
1. Keep chisels and bits sharp.
2. A typical mortis operation is illustrated in Fig. 29. Note
that the opening (A) in the chisel is to the right. Move
your work piece from left to right for subsequent cuts to
allow chips to escape freely.
3. Hold the work piece firmly against the fence. Ensure
that the hold-down (B) Fig. 27 is properly adjusted. The
rate of penetration of the chisel must be fast enough to
prevent burning at the tip of the bit, but not too fast as
to stall the motor. You may encounter smoke from the bit
work piece. Smoke is a natural operating occurrence, caused by friction and burning of resins. Bluing of the chisel
after initial use is not indicative of a dull chisel, but rather is a combination of friction and built-up resin on the
cutting face of the chisel. You can detect a dull chisel by the amount of excess force required to complete a cut.
4. When performing a through mortise, place a thin piece of wood between the work piece and the table to prevent
"chip-out" at the bottom of the mortise.
B
Fig. 27
C
E
C
B
12
F
Fig. 26
B
A
Fig. 28
A
Fig. 29