Husqvarna 3120XP Manuel D'utilisation page 9

not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the guide bar and saw
chain
1. Disengage the chain brake.
2. Loosen the bar nut and remove the clutch cover.
Note: If the clutch cover is not easy to remove,
tighten the bar nut, engage the chain brake and
release. A click is heard if it is released correctly.
3. Assemble the guide bar onto the bar bolt. Move the
guide bar to its most rear position.
4. Install the saw chain correctly around the drive
sprocket and put it in the groove on the guide bar.
WARNING: Always use protective
gloves when you assemble the saw
chain.
5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
1527 - 001 - 25.06.2020
Assembly
6. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover.
7. Tighten the bar nut finger tight.
8. Tighten the saw chain. Refer to
of the saw chain on page 28 for instructions.
9. Tighten the bar nuts.
Note: Some models have only 1 bar nut.
To adjust the tension
9