Husqvarna 3120XP Manuel D'utilisation page 23

4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that the
saw chain stops and stays stationary.
WARNING: If the saw chain rotates
when the throttle trigger is in the idle
position, speak to your servicing dealer.
To do a check of the chain catcher
1. Make sure that there is no damage on the chain
catcher.
2. Make sure that the chain catcher is stable and
attached to the body of the product.
To do a check of the right hand guard
• Make sure that the right hand guard is not damaged
and that there are no defects, such as cracks.
To do a check of the vibration damping
system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Product overview on page 2 for information
Refer to
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Start the engine.
1527 - 001 - 25.06.2020
2. Push the start/stop switch to the STOP position. The
engine must stop.
To do a check of the muffler
WARNING: Do not use a product that has a
defective muffler or a muffler that is in bad
condition.
WARNING: Do not use a product if the spark
arrestor mesh on the muffler is missing or
defective.
1. Examine the muffler for damages and defects.
2. Make sure that the muffler is correctly attached to
the product.
3. If your product has a special spark arrestor mesh,
clean the spark arrestor mesh weekly.
4. Replace a damaged spark arrestor mesh.
CAUTION: If the spark arrestor mesh is
blocked the product becomes too hot and
this causes damage to the cylinder and
piston.
23