Maintenance; Fixing Problems - Wolf Garten HSE 45 V Mode D'emploi

Maintenance

General
1
Attention! Reverse blade
Before all maintenance and cleaning work:
Pull out the power plug.
Do not touch moving blades.
Cleaning
Clean the hedge shears with a dry towel, par-
ticularly the ventilation slits, after each use or
using a brush in the case of heavy soiling.
Spray the blades with oil after each use.
Under no circumstances spray the hedge
shears off with water.

Fixing problems

Problem Possible cause
• Dull blade.
Blade gets hot.
• Too much friction due to inadequate lu-
• Not connected to voltage supply
• Cable damage:
1
Motor does not
run.
Jittery operation, • Blade damaged
heavy vibration
• Blade not firmly in stabilizer.
of the device
When in doubt, always seek out a WOLF Service location.
1
Put down the hedge shears and pull out the power plug before performing any checks or
work on the blades.
G
brication
Attention! Electric shock
through cable damage
When the cable is cut through or
damaged, the safety fuse does not
always trip.
Do not touch cable before pull-
ing out the power plug out of
the socket.
Storage
Store the hedge shears in the blade scabbard
provided.
–
For easy storage the blade scabbard can be
mounted on the wall
–
We recommend using the drill template (see
page 136) for simple wall-mounting of the
blade scabbard.
Store the hedge shears in a dry location out of
the reach of children.
Solution
• Go to a WOLF Service location.
• Oil blades
• Check the power supply and have
electrician perform repairs if neces-
sary.
• Have damaged cable completely re-
placed at WOLF Service location.
Patching the cable with insulating tape
is forbidden.
• Go to WOLF Service location.
• Go to WOLF Service location.
K L
.
17