Hilti DSH 900-X Mode D'emploi Original page 34

▶ Guide the product smoothly and do not apply lateral pressure to the cut-off wheel. Always bring the
cut-off wheel into contact with the workplace at right angles. Don't attempt to alter the line of cut by
applying lateral pressure or by bending the cut-off wheel while cutting is in progress.
▶ Abrasive cut-off wheels which are used for wet cutting must be used up the same day as long periods of
exposure to moisture have a negative effect on the strength of the wheel.
▶ Never install a cut-off wheel for cutting wood.
▶ Use only cut-off wheels that comply with the existing standards for cut-off wheels.
▶ Prior to installation and before use, check the cut-off wheel for damage. Do not install a damaged cut-off
wheel. Comply with the requirements stated by the manufacturer of the cut-off wheel.
▶ Observe the expiry date for resin-bonded cut-off wheels and don't use the wheels after this date.
3 Description
3.1 Product overview
3.1.1 Gasoline-powered cut-off saw
26 English
1
Guard
@
Water supply
;
Front grip
=
Water valve
%
Pull start
&
Fuel tank cap
(
Throttle trigger
)
Rear grip
+
Fuel-level sight glass
§
Guide rollers
/
Cut-off wheel
:
Clamping screw
∙
Clamping flange
$
Spark plug connector
£
Decompression valve
|
Throttle safety grip
¡
Run/stop switch with half-throttle lock
Q
Primer bulb
W
Water connection
E
Grip for guard adjustment
R
Cut-off wheel direction-of-rotation indicator
T
(arrow at front of guard)
Saw arm
Z
Hole for locking pin for changing cut-off
U
wheel
Pump cover
I
Air filter cover
O
2271384
*2271384*