SEVERIN HT 0156 Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
∙ Protect the appliance from moisture and
splashing water and do not operate it
with wet hands.
∙ Electric heating appliances operate at
very high temperatures. Do not touch
any part of the appliance except the
grip. Otherwise there is a real risk of
burning.
∙ Do not use the appliance on synthetic
hair-pieces or wigs, as the heat emitted
might cause damage to the synthetic
fibres.
∙ Make sure the air intake and outlet
openings are not blocked (e.g. by
fingers or hair), and that no fluff or fibre
particles are allowed to accumulate in
the air intake.
∙ A blockage in the air-flow system may
cause the integral thermal safety cut-out
to switch off the appliance. Should
this occur, immediately disconnect the
appliance from the mains power and
allow sufficient time for it to cool down
before the blockage is removed and the
appliance is switched on again.
∙ Every time the appliance is used, the
main body including the power cord as
well as any attachment fitted should
be checked thoroughly for any defects.
Should the appliance, for instance, have
been dropped onto a hard surface, or if
excessive force has been used to pull
the power cord, it must no longer be
used: even invisible damage may have
adverse effects on the operational safety
of the appliance.
∙ To prevent damage to the power cord,
- do not bend or kink the cable,
especially where it leaves the housing,
- do not pull on the cord,
- do not coil the power cord around the
appliance.
∙ Always switch off and remove the
plug from the wall socket after
use, and also in the event of any
malfunction.
∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
Intended use
This appliance is intended solely for drying
and shaping natural hair. Any other use
must be considered improper and may lead
to personal injuries or material damage.
Styling nozzle
The styling nozzle can be fitted to the
air outlet. It focuses the air-flow, helping
to blow-dry and shape the hair more
effectively.
Operation
∙ Fold out the handle.
∙ Set the voltage regulator to your supply
voltage.
∙ Connect the dryer to a suitable wall
socket.
∙ Use the slide switch in the grip to select
the desired power setting.
∙ Switch the appliance off after use and
disconnect it from the mains.
11

Publicité

Table des Matières
loading

Table des Matières