Publicité
Les langues disponibles
Les langues disponibles
V1.0
Secure each bolt with an M6 flange nut inside the blasting cabinet's
chamber.
14. Plug the dust collector's power cable into the power outlet on the rear of
the electric box assembly.
15. Move the assembled cabinet to the chosen location in the work area
before proceeding with the remaining steps.
•
You can remove the front brace (#16) from the legs once the blasting
cabinet is in place. This is to allow easy access to the foot pedal
during use.
16. Attach the pressure gauge and regulator valve assembly (#12) to leg B
(#10) with two M6 x 12 screws (#2).
17.
Place the foot pedal (#15) between the front legs.
18. Connect the left air hose (#56) from the foot pedal to the barb connector
on the air regulator (#12).
19. Remove the compression nut from the hopper's brass fitting on the right-
hand side. Slide the compression nut onto the foot pedal's other air hose,
Insert the air hose through the brass fitting opening. Gently pull enough
hose into the blasting cabinet for comfortable use. Slide the compression
nut back onto the port's threads and tighten to lock the air hose in place.
20. Install the siphon hose end into the media hopper. Secure it with the
bracket.
21. Place the floor grates with cut out corner to front right of cabinet. Guide
the siphon and air gun hoses through opening during installation.
22. Place both floor grates into the blasting cabinet. The rectangular grate (#4)
is placed on the left-hand side. The grate with the cut-off corner (#5) is
placed on the right-hand side.
23. Tighten all bolts, nuts and screws in the abrasive blasting cabinet.
24. Position the media siphon hose (#3) and the air hose through the right-
hand grate opening.
25. Screw the air hose into the abrasive blasting gun's air inlet (#55) until
tight.
Page 9
ABRASIVE BLASTING CABINET
www.princessauto.com / 1-800-665-8685
9175365
Publicité
