Publicité
Les langues disponibles
Les langues disponibles
V1.0
3.
Avoid unintentional starts. Be sure that the regulator/throttle switch is in
the neutral or OFF position when not in use and before connecting it to
any air source.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace
the missing part before operating. Failure to do so could result in a
malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
CONTENTS
Make sure that all items in the parts list are included.
• Abrasive Blasting Cabinet
ASSEMBLY & INSTALLATION
Some components are heavy and difficult to maneuver while installing.
Have another person available to help you during installation.
Some components may be preassembled at the factory.
1.
Disassemble the packaging to remove the cabinet components.
2.
Place the upside-down base (#8) on a level surface.
3.
Attach Leg B (#10) to the front right corner of the upside-down base with .
Leg B will have two holes near the wider end of the leg. This side aligns
with the longer side of the base.
4.
Attach the remaining three legs (#18) to the other corners with .
5.
Attach a short connecting brace (#18) to the inside of two legs on the
short side of the base. Screw two through the legs and into the brace.
Repeat on the other side.
6.
Attach the long connecting braces (#17) inside the legs with on each side.
Page 7
ABRASIVE BLASTING CABINET
www.princessauto.com / 1-800-665-8685
9175365
Publicité
