Publicité
Les langues disponibles
Les langues disponibles
9175365
Store abrasive in a dry location. Wet abrasive will clog the unit.
Recommended Abrasive Blasting Media for this model:
1.
Aluminum oxide grit
2.
Glass bead
3.
Crushed glass
4.
Steel shot
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Keep the tool handles or gripping surfaces clean and dry.
4.
Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
ABRASIVE BLASTING MAINTENANCE
Disconnect air source before performing any maintenance.
1.
The nozzle will wear away over time, causing the internal diameter to
widen and disperse the media over a larger area, reducing the tool' s
efficiency. The compressor will also need to work harder to maintain the
pressure. Check at regular intervals and replace as appropriate.
2.
Dust will occur if the abrasive blasting media is worn out. If it has lost its
granular or spherical appearance or has a lot of debris mixed in from the
parts being blasted, replace the abrasive blasting media. This is usually
noticed when the abrasive media that exits the nozzle resembles more of
a cloud than a stream.
www.princessauto.com / 1-800-665-8685
ABRASIVE BLASTING CABINET
5.
6.
7.
Copper slag
Garnet
Crushed nutshells
V1.0
Page 12
Publicité
