Power Fist 9175365 Manuel D'utilisation page 14

9175365
2. The air outlet vent is plugged or air flow out is blocked. Cleaning this
vent should help reduce dust in the cabinet. The gun parts may wear out.
This is usually evident when the blast pattern is too wide and ineffective;
simply replace the nozzle or orifice.
a. You can extend the nozzle's lifespan by checking it for uneven wear
every 10 to 12 hours. Twist the nozzle a quarter turn to compensate
for this wear.
3. Check the nozzle's inner diameter from time-to-time or when the media
spray seems too diffuse. Replace when the nozzle's inner diameter
increases by 1/16 in. or more.
ACRYLIC WINDOW MAINTENANCE
The viewing and lamp windows have an interior replaceable plastic film to
protect them from the abrasive media. Remove the heavily pitted plastic
protectors and replace with the new films.
1. Remove the (#20) from the viewing window bracket (#20). Set the screws
and bracket aside.
2. Remove the rigid plastic sheet (#22) and glass (#23). Set both aside.
3. Remove and discard the protective film (#24).
4. Place a new protective film in place. Place the glass and rigid plastic sheet
on top of the film.
5. Place the bracket over the window and secure with the screws.
CLEANING
Wipe the tool with a clean cloth and periodically blow out all areas with
compressed air. If compressed air is not available, use a brush to remove dust
from areas. Do not use harsh chemicals or solvents to clean the tool. These
chemicals could seriously damage the housing.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
www.princessauto.com / 1-800-665-8685
ABRASIVE BLASTING CABINET V1.0
Page 14