Hilti VC 20MX-ACD Manuel D'utilisation page 28

1. Select an operating mode.
2. Vacuum up the dry dust.
After vacuuming up dry dusts
3. Empty the waste material container.
4. Clean the vacuum cleaner with a damp cloth.
5. Position the suction head on the waste material container.
6. Check the main filter for damage.
▶
Replace a damaged main filter.
Vacuuming up liquids
1. Check the container level monitoring system.
2. If possible, use a separate main filter for wet applications.
For information about suitable filters, consult the instructions for use for accessories
3. Select an operating mode.
4. Use the vacuum cleaner to vacuum up the liquids.
After vacuuming up liquids
5. Remove the suction head from the waste material container.
6. Empty the waste material container.
7. Check the container level monitoring system.
8. Check the main filter for damage.
▶
Replace a damaged main filter.
9. Position the suction head on the waste material container.
System applications
Using overcurrent protection circuit-breaker
Only for the Australia and New Zealand markets
The fuse protects the electric tool power outlet from current spikes. If the fuse trips, the overcurrent protection circuit-breaker (white)
appears underneath the transparent cover. To keep the fuse from tripping again, rectify the cause of the problem (e.g. disconnect the
electrical device from the electric tool power outlet).
▶
To restore the AC supply to the electrical device connected to the power outlet, press the overcurrent protection circuit-breaker.
Operation with use of the power outlet on the appliance
The power outlet on the appliance is to be used only for powering electric tools directly from the vacuum cleaner.
The operating instructions and safety instructions for the electric tool plugged into the power outlet on the vacuum cleaner must be observed.
Only for the Switzerland and Liechtenstein markets: Use the electric tool power outlet only for applications in dry ambient conditions.
1. Unplug the vacuum cleaner's supply cord from the power outlet.
2. Check that the maximum power drawn by the electric tool is below the maximum permissible output of the power outlet on the vacuum
cleaner (please refer to the "Technical data" section of the operating instructions and information printed at the power outlet on the appliance).
3. Check to ensure that the electric tool is switched off before plugging its supply cord into the power outlet.
4. Plug the electric tool's supply cord into the power outlet on the vacuum cleaner.
5. Plug the vacuum cleaner's supply cord into the power outlet.
6. Turn the control switch to the "Auto" position.
7. Switch on the power tool.
The vacuum cleaner will continue to run for a short time after the electric tool is switched off in order to ensure that all dust is removed
from the suction hose.
Operation without use of the electric tool power outlet
1. Before plugging the supply cord into a power outlet, check that the control switch is in the OFF position.
2. Plug the vacuum cleaner's supply cord into the power outlet.
3. Turn the control switch to the ON position.
Care and maintenance
Instructions for care of vacuum cleaners
WARNING
Electric shock hazard! Improper repairs to electrical parts can lead to serious injuries due to electric shock.
▶
Electrical parts may be repaired only by trained electrical specialists.
• Carefully remove stubborn dirt.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as these can attack the plastic parts.
23
22
24
24
25
22
24
25
24
5
21
21
21
18.
*2418904*
2418904