Publicité
Les langues disponibles
Les langues disponibles
Replace the grass catcher.
5. If mower should start to vibrate abnormally,
release bail handle to turn mower off and remove
safety key. Check immediately for cause. Vibration
is a warning of trouble. Do not operate mower
until a service check has been made. Refer to
troubleshooting guide in manual.
6. ALWAYS RELEASE BAIL HANDLE TO TURN
MOWER OFF AND REMOVE SAFETY KEY
WHEN LEAVING IT UNATTENDED EVEN
FOR A SHORT PERIOD OF TIME.
THE FOLLOWING SUGGESTIONS WILL HELP
YOU TO OBTAIN OPTIMUM RUN TIME FROM
YOUR CORDLESS MOWER:
1. Slow down in areas where the grass is especially
long or thick.
2. Avoid mowing when the grass is wet from rain
or dew-soaked.
3. Cut your lawn frequently, especially during high
growth periods.
NOTE: IT IS RECOMMENDED THAT YOUR
MOWER BE RECHARGED AFTER USE TO
PROLONG THE BATTERY LIFE. FREQUENT
CHARGING WILL NOT HARM YOUR BATTERY,
AND WILL ENSURE THAT THE BATTERY
IS FULLY CHARGED AND READY FOR ITS
NEXT USE. STORING BATTERY NOT FULLY
CHARGED WILL SHORTEN BATTERY LIFE.
REMOVING AND INSTALLING BLADE
DANGER:
RISK OF INJURY. WHEN
REASSEMBLING THE BLADE SYSTEM, ENSURE
EACH PART IS REINSTALLED CORRECTLY, AS
DESCRIBED BELOW. IMPROPER ASSEMBLY OF THE
BLADE OR OTHER PARTS OF THE BLADE SYSTEM
MAY CAUSE SERIOUS INJURY.
WARNING:
1.
RELEASE BAIL HANDLE TO
TURN MOWER OFF, WAIT FOR THE BLADE TO
STOP, AND REMOVE SAFETY KEY AND
BATTERY PACK.
2. Cut a piece of 2x4 wood (31) (about 2 feet
long) (610 mm) to keep blade from turning
while removing bolt (32).
3. Wear gloves and proper eye protection. Turn the
mower on its side. Be careful of sharp edges of
blade. Position wood and unscrew bolt with1/2"
wrench (33) as shown in Figure W.
W
31
4. Remove bolt and washer (34). Pull off blade
(35) as shown in Figure X. The fan (36) should
not be removed. Examine all pieces for damage
and replace if necessary.
X
34
32
5. The blade can only be attached to the fan in one
direction. To reassemble, line up the D-shaped
hole of the blade with the D-shaped post of the
fan, ensuring the writing on the blade faces out
away from the mower.
6. To tighten firmly, position the piece of wood
as shown in Figure Y to keep the blade from
turning. Slide the bolt through the washer and
screw bolt into place. Tighten with the wrench.
Y
BLADE SHARPENING
KEEP BLADE SHARP FOR BEST MOWER PERFORMANCE.
A DULL BLADE DOES NOT CUT GRASS CLEANLY.
USE PROPER EYE PROTECTION WHILE REMOVING,
13
33
32
36
35
Publicité
