Publicité
Les langues disponibles
Les langues disponibles
K
9
MULCHING
• Ensure the side discharge attachment (27) and the
collection bag (8) are not attached.
• Lift the rear door cover (9) and slide the
mulching insert (26) fully into the mower as
shown in Figure L.
• Ensure the rear door cover fully closes before
turning mower on.
L
SIDE DISCHARGE
• Ensure the collection bag (8) is removed.
• Lift the rear flap (9) and slide the mulching
insert (26) fully into the mower as shown in
Figure L.
• Lift the side flap (28) and hook side discharge
attachment (27) onto the mower as shown in
Figure M.
• Release the side flap and ensure the attachment
holds in place before turning mower on as
shown in the insert of Figure M.
M
28
8
24
25
26
27
OPERATION
READ THIS INSTRUCTION MANUAL BEFORE
OPERATING YOUR MOWER. See "Functional
Description" on page 5 to familiarize yourself
with the location of various controls and
adjustments. Save this manual for future reference.
WARNING:
Sharp moving blade. Do not
operate the mower in side discharge or mulching
mode if the rear door is not closed under spring
tension as serious injury could result. Take your mower
to the nearest service center for repair.
DANGER:
Sharp moving blade. Never
operate the mower in bagging mode unless the
hanger hooks on the grass catcher are seated
properly on the mower and the rear discharge
door rests firmly against the top of the grass
catcher as serious injury could result.
WARNING:
Let the mower work at its own
pace. Do not overload.
ADJUSTING HANDLE HEIGHT (FIGURE N)
• Open both lower-handle attachment levers (6).
• Adjust the handle so the arrow (18) on the base
of the mower lines up with 1, 2, or 3 on the base
of the handle (19). Ensure the handle is set to the
same number on both sides of the mower.
• Close both levers and ensure the handle is
firmly latched.
N
ADJUSTING MOWER HEIGHT (FIGURE O)
The height of cut is adjusted by the central
cut height adjust lever, there are 7 positions to
choose from.
NOTE: If you are not sure which height to cut,
begin mowing with the height adjustment lever
(7) in position 7 and adjust the height down as
needed, as shown in Figure O.
To set the height of cut:
• Pull the mower height adjustment lever out of the
locking notch.
• Move the lever towards the rear of the appliance to
lower the height of cut.
• Move the lever towards the front of the appliance
to raise the height of cut.
• Push the height adjustment lever into one of
the 7 locking notches.
10
19
18
6
Publicité
