Würth 5701 402 00 Traduction Des Instructions De Service D'origine page 32

9. Battery pack
10. Clamp nut
11.
12. 2-in-1 cutting guard (not included)
13. Cutting wheel (not included)
Intended Use
The angle grinder is intended to be used only by
adults who have read and understood the instructions
and warnings in this manual and can be considered
responsible for their actions. The angle grinder is
designed for grinding and cutting metals only. Only
appropriate grinding discs as described in the product
the angle grinder. The angle grinder is designed for
workbench.
Do not use the product in any way other than those
stated for intended use.
Protection Feature
The product is equipped with protection features which
Refer to the following tables for the protection features
and LED functions of the product.
Over Current Protection
Status
Over-current 100A ±10%
@1000 ms
Over-current 120A ±10% @400
ms
Over-current 160A ±10% @1 ms
Over Temperature Protection
Status
FET temperature over 90 ± 5°C
@ 10 ms
NOTE: Power output will resume when temperature
drops to 70°C. Release the switch and press again to
activity the product.
Low Voltage Protection
Status
0.6V @ 300 ms
NOTE: Power output will resume when battery pack
voltage is higher than 13.2V. Release the switch and
press again to activity the product.
Communication
Pack Abnormal
Status
Communication between battery
pack and tool interrupted.
Battery pack is abnormal.
LED
Flashes 4 times
LED
Flashes 10
times
Interruption/Battery
Symbols
Read all safety warnings and all
instructions.
Warning
Always wear eye protection.
V Volts
Direct current
No-load speed
Rated speed
CE conformity
Waste electrical products should
not be disposed of with household
waste. Please recycle where facilities
exist. Check with your local authority
or retailer for recycling advice.
LED
Flashes 6 times
LED
Blinks 2 cycles
32