SilverCrest 315413 Instructions D'utilisation Et Consignes De Sécurité page 12

Note: The blades can be oiled with or without
comb attachment
11
Operation
Changing the attachments
Carefully place the desired comb attachment
onto the product as depicted in Fig. F. Ensure
that both recesses of the comb attachment
properly engage into the lateral detents at both
sides above the cutting unit
To remove the comb attachment
slide it forward and upwards using both thumbs,
as depicted in Fig. G.
Setting the trim length
To set different trim lengths, hold the upper part
of the product and twist the lower part of
2
the product into the desired position
5
(0.8–2.0 mm). The set trim length will be dis-
played on the length position indicator
which aligns with the dot-marking on the upper
part of the product
Trimming hair
Note: The hair being trimmed should be clean,
dry and untangled.
Carefully comb the hair using the supplied
comb to disentangle any potential knots.
17
Place the hairdressing cape
neck and nape to prevent bits of hair from
falling into the collar.
Begin by using the longer comb attachment
and trim the hair gradually to the desired length.
12 GB/IE/NI
and thinning attachment
.
1
, press and
11
4
.
2
around the
15
Note that the desired trim length can only be
. achieved if the product is held perpendicularly
12
to the skin's surface.
Avoid making sudden movements when
trimming.
Switch the product on by pressing down the
travel lock
3a
to the "I" position. To maximize performance,
3b
slide the ON / OFF switch
11
position. The Turbo display
the display if this is the case.
11
Always trim from the nape in the direction of
the top of the head, or from the forehead and
temples towards the centre of the head.
Guide the product slowly and steadily through
the hair. If possible, trim against the direction
of the hair's growth.
While doing so, hold the product in such a
way that the selected comb attachment
positioned as level as possible.
Move the product over the head several times
to collect all of the hair. To achieve a straight
line, move the product through the hair several
times from different directions.
Comb the hair repeatedly.
You can graduate the desired trim length of
the comb attachment
rotating the lower part of the product
cording to length position indicator
gradations differ by 0.3 mm.
Example:
Comb attachment 3.0 mm (trim length
3.8–5 mm):
Furthermost left
position (0.8 mm): short hair (3.8 mm)
Middle
position (1.4 mm): mid-length hair (4.4 mm)
Furthermost right
position (2.0 mm): long hair (5.0 mm)
11
and sliding the ON / OFF switch
to the "Turbo"
3b
will appear on
8
more accurately by
11
4
is
11
ac-
5
. These