Publicité
Les langues disponibles
Les langues disponibles
Before use
Note: The product may be powered using the
built-in rechargeable battery or the plug-in mains
adapter.
Remove all parts from the package.
Charging
Note: Before first use, the rechargeable battery in
the product should be charged for at least 90 minu-
tes. A charging time of 90 minutes is also required
subsequently.
The product can be charged directly or indirectly by
using the charging base
Note: The charging process is shown on the display
of the charging display
display
.
10
Direct charging (see Fig. C)
To avoid injuries and damage to the product,
always switch the product off before charging
the battery (ON / OFF switch
"0" position).
Insert the cable plug of the plug-in mains ad-
apter
into the socket on the underside of
7
the product.
Insert the plug-in mains adapter
socket which meets the product requirements.
Indirect charging (see Fig. D)
To avoid injuries and damage to the product,
always switch the product off before charging
the battery (ON / OFF switch
"0" position).
Connect the cable plug of the plug-in mains
adapter
with the charging base
7
Place the product into the recess of the char-
ging base
with the cutting unit
6
upwards.
Insert the plug-in mains adapter
socket which meets the product requirements.
.
6
and the battery-status
9
set to the
3b
into a
7
set to the
3b
.
6
pointing
1
into a
7
Note: During the charging process, the red
charging display
will light up and the battery
9
status display
will show the battery level.
10
Note: As soon as the battery is charged, the
battery status display
10
charging display
will continue to be red.
9
Note: You can use the product for up to approx.
60 minutes with a full battery without it being
connected to the power supply.
Note: When the battery is almost empty, the char-
ging display
on the display will flash. Then, the
9
product may only be used for a short period of
time without being connected to the power supply.
Operating using the plug-in mains adapter:
If the product stops working during use due to an
empty or insufficient battery, you can continue if
the plug-in mains adapter is connected.
Insert the cable plug of the plug-in mains ad-
apter
into the socket on the underside of
7
the product.
To avoid injuries and damage to the product,
always switch the product off before connecting
to the plug-in mains adapter
Insert the plug-in mains adapter
socket which meets the product requirements.
After a few seconds you can switch on the pro-
duct by pressing down the travel lock
sliding the ON / OFF switch
position for the desired speed. If the product
does not start working immediately, switch it
off by sliding the ON / OFF switch
"0" position. Wait approx. 1 minute before
you try to switch it on again.
Oiling the blades
It is recommended that you oil the blades before
first use and after cleaning to guarantee complete
functionality (see Fig. E).
Apply one or two drops of blade oil
ween the blades and distribute them evenly.
Wipe away any excess oil using a cloth.
You can also use any acid-free oil such as
sewing machine oil.
will switch off, while the
.
7
into a
7
and
3a
into the desired
3b
to the
3b
bet-
14
GB/IE/NI
11
Publicité
