SilverCrest HG05616A Instructions D'utilisation Et Consignes De Sécurité page 10

Weigh and add
Q
The product allows you to weigh foods consecutively
without removing food already in the weighing
bowl .
1
Place the weighing bowl
Press the ON / OFF button
product on.
Select the unit of weight by pressing the unit of
weight button (UNIT) / Timer button
described in "Weighing" section.
Place the food you wish to weigh in the weigh-
ing bowl .
1
The LCD readout
4
food in the selected unit of weight.
Now press the TARE button / Timer button
The numerical display
ing. The TARE symbol
Now place more food in the weighing bowl
The LCD readout
4
the food you have added in the selected unit
of weight.
Continue in this way only until the maximum ca-
pacity of the product is reached or the weighing
bowl is full.
1
Remove part of the
Q
weighed food
Place the weighing bowl
Press the ON / OFF button
product on.
Select the unit of weight by pressing the unit of
weight button (UNIT) / Timer button
described in "Weighing" section.
Place the food you wish to weigh in the
weighing bowl .
1
The LCD readout
4
food in the selected unit of weight.
Now press the TARE button / Timer button
The numerical display
The TARE symbol
Now remove the required amount of food from
the weighing bowl
10 GB/IE/NI
on the product.
1
to switch the
2
as
5
indicates the weight of the
will show zero read-
9
will appear.
13
indicates the weight of
on the product.
1
to switch the
2
as
5
indicates the weight of the
will show zero reading.
9
will appear.
13
.
1
The LCD readout
indicated by the minus symbol
Now press the TARE button / Timer button
The numerical display
The TARE symbol
Set the countdown timer / alarm
Q
The timer on the product has a time span of 00:10
to 99:50 minutes. The set time is counted down in
reverse to "00:00". An alarm signal then sounds
and the alarm display
Press the ON / OFF button
product on.
. Press the Timer button (T-SET)
6
display
14
Set the required time by pressing the unit of
. weight button (UNIT) / Timer button
1
the TARE button / Timer button
Press the Timer button (T-SET)
firm the set time and to start the countdown timer.
Press the Timer button (T-SET)
the countdown timer.
Press the Timer button (T-SET)
the set time to "00:00". The alarm display
will disappear.
Note: When the set time has elapsed, an alarm
signal sounds.
Press the ON / OFF button
and at the same time switch off the product.
Display ambient temperature
Q
When the product is switched on, the LCD readout
shows the current ambient temperature. This is
4
indicated by the temperature display
Switch off the product
Q
.
6
The product switches itself off automatically after
90 seconds of inactivity to save energy.
will show a negative value
4
.
12
will show zero reading.
9
will disappear.
13
flashes.
14
to switch the
2
. The alarm
3
will appear.
.
6
again to con-
3
again to stop
3
again to reset
3
to stop the alarm
2
in °C.
10
.
6
or
5
14