SilverCrest STK 16 B3 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 12

Assembly
Note: You will need a screwdriver and a drill to assemble the product.
Note: Only use the screws and dowels supplied for the assembly of
the product.
Mount the receiver (see Fig. D)
Mount the transmitter (see Fig. E)
Preparing for use
For first time use, please remove the protective foil from the name
plate of the transmitter and insert your name plate into the recess on
the transmitter.
Replace the protective foil on the transmitter.
Inserting / replacing the batteries
Insert the batteries to provide power to the product before pre-
paring it for use.
CAUTION! Use the indicated battery types only. Failure to ob-
serve this advice may result in damage to the product.
Receiver (see Fig. B):
Remove the battery compartment cover
receiver.
12 GB/IE/NI
from the back of the
6