Dyson V7 Manuel D'utilisation page 39

Masquer les pouces Voir aussi pour V7:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
To detach the clear bin from the appliance, pull back on the red
catch located at the base, slide the clear bin down and carefully
remove forwards from the main body.
Clean the clear bin with a damp cloth only.
Do not use detergents, polishes or air fresheners to clean the
clear bin.
Do not put the clear bin in a dishwasher.
Ensure the clear bin is completely dry before replacing.
To replace the clear bin, align the tabs on the clear bin with the
grooves on the main body and slide upwards into place until the
catch clicks.
Slide the cyclone into the grooves of the main body and push
downwards until it is in its normal position and manually close the
base of the bin – the base will click when it is securely in place.
Washable parts
Washing the brush bar
Your appliance has a washable brush bar, check and
wash it regularly according to the following instructions to
maintain performance.
Ensure the appliance is disconnected from the charger before
removing the brush bar. Be careful not to pull the 'ON' trigger.
To remove, wash and replace the brush bar:
Please refer to the 'Washing the brush bar' illustrations alongside the
instructions below.
Turn the cleaner head upside down so the underside of the cleaner
head is facing you. Use a coin to turn the fastener one quarter anti-
clockwise to the unlocked position.
Rotate the end cap to the open position. Gently slide the brush bar
away from the cleaner head.
Remove the end cap from the brush bar.
Hold the brush bar under running water and gently rub to remove
any lint or dirt.
Stand the brush bar upright as shown. Leave to dry completely for a
minimum of 24 hours.
Before replacing, check that the brush bar is completely dry.
Reattach the end cap to the brush bar.
Slide the brush bar back onto the cleaner head, around the motor.
The end cap should be in the open position as shown. Once in
place, rotate the end cap back into the closed position.
Close the fastener by turning a quarter turn clockwise. Ensure that
the fastener is fully turned and the brush bar is secure.
Your appliance has washable parts, which require regular cleaning.
Follow the instructions below.
Washing your filter
Ensure the appliance is disconnected from the charger before
removing the filter. Be careful not to pull the 'ON' trigger.
Your appliance has one washable filter, located as shown.
To remove the filter, lift it out of the top of the appliance.
Check and wash the filter regularly according to instructions to
maintain performance.
The filter may require more frequent washing if vacuuming fine dust
or if used mainly in 'Powerful suction' mode.
Wash the filter with cold water only.
Run water over the outside of the filter until the water runs clear.
Squeeze and twist with both hands to make sure the excess water
is removed.
Lay the filter on its side to dry. Leave to dry completely for a
minimum of 24 hours.
Do not put the filter in a dishwasher, washing machine, tumble
dryer, oven, microwave or near a naked flame.
To refit, place the dry filter back into the top of the appliance. Make
sure it is seated properly.
Blockages – automatic cut-out
This appliance is fitted with an automatic cut-out.
If any part becomes blocked the appliance may automatically
cut out.
23.05.2017 09:37 - C90136_SV11_OPMAN_EU_X285A-V7-ABSOLUTE-NON-HEPA-OPMAN-90136.indd_15_4c0s
This will happen after the motor pulses a number of times
(i.e switches on and off in quick succession).
Leave to cool down before looking for blockages.
Ensure the appliance is disconnected from the charger
before looking for blockages. Failure to do so could result in
personal injury.
Clear any blockage before restarting.
Refit all parts securely before using.
Clearing blockages is not covered by your guarantee.
Looking for blockages
The motor will pulse when there is a blockage. Please follow the
instructions below to locate the blockage:
Ensure the appliance is disconnected from the charger before
looking for blockages. Be careful not to pull the 'ON' trigger.
Do not operate while checking for blockages. Doing so could result
in personal injury.
Beware of sharp objects when checking for blockages.
To check for blockages in the main body of the appliance, remove
the clear bin and cyclone as per the instructions in the cleaning
the clear bin section and remove the blockage. Please consult the
'Stubborn blockages' section of the illustrations for further guidance.
If you cannot clear an obstruction you may need to remove the
brush bar. Use a coin to unlock the fastener marked with a padlock.
Remove the obstruction. Replace the brush bar and secure it by
tightening the fastener. Ensure it is fixed firmly before operating
the appliance.
This product has carbon fibre brushes. Take care if coming into
contact with them, as they may cause minor skin irritation. Wash
your hands after handling the brushes.
Refit all parts securely before using.
Clearing blockages is not covered by your guarantee.
Charging and storing
This appliance will switch 'OFF' if the battery temperature is below
3°C (37.4°F). This is designed to protect the motor and battery.
Do not charge the appliance and then move it to an area with a
temperature below 3°C (37.4°F) for storage purposes.
To help prolong battery life, avoid recharging immediately after a
full discharge. Allow to cool for a few minutes.
Avoid using the appliance with the battery flush to a surface. This
will help it run cooler and prolong battery run time and life.
Battery safety instructions
If the battery needs replacing please contact the Dyson Helpline.
Use only Dyson chargers for charging this Dyson appliance.
The battery is a sealed unit and under normal circumstances
poses no safety concerns. In the unlikely event that liquid
leaks from the battery do not touch the liquid and observe the
following precautions:
– Skin contact – can cause irritation. Wash with soap and water.
– Inhalation – can cause respiratory irritation. Expose to fresh air
and seek medical advice.
– Eye contact – can cause irritation. Immediately flush eyes
thoroughly with water for at least 15 minutes. Seek medical
attention.
– Disposal – wear gloves to handle the battery and dispose of
immediately, following local ordinances or regulations.
CAUTION
The battery used in this device may present a risk of fire or
chemical burn if mistreated. Do not disassemble, short contacts,
heat above 60°C (140°F), or incinerate. Keep away from children.
Do not disassemble and do not dispose of in fire.
Online support
For online help, general tips, videos and useful information
about Dyson.
UK - www.dyson.co.uk/support
ROI - www.dyson.ie/support
39

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

V8 animal +

Table des Matières