M-Audio M-TRACK 2X2M C Série Guide D'utilisation page 5

Rear Panel
1. USB Port (Type C): This connection
will allow you to send audio and MIDI
data to and from a computer. Use the
included USB-C-to-USB-C or USB-
C-to-USB-A cables to connect the
M-Track 2X2M to a computer. The
M-Track 2X2M requires a USB 2.0
connection (or higher).
2. Combo Inputs: Connect microphones, a guitar or bass with an active pickup, or line-
level devices to these inputs. For microphones, use an XLR or 1/4" (6.35 mm) TRS cable.
For a guitar or bass with an active pickup, use a standard 1/4" (6.35 mm) TS cable. For
line-level signals, use a 1/4" (6.35 mm) TRS cable. View the input signal levels with the
LED Meters.
3. Main Outputs: Use standard 1/4" (6.35 mm) TRS cables to connect these outputs to
your powered monitors, amplifier system, etc. The mix you hear from these output will be
determined by the USB / Direct Blend knob. The level of these ouputs is controlled by
the Monitor Level knob.
4. MIDI In: Use a standard five-pin MIDI cable to connect this input to the MIDI Out of an
external MIDI device.
5. MIDI Out: Use a standard five-pin MIDI cable to connect this output to the MIDI In of an
external MIDI device.
6. Kensington Lock Slot: You can use this Kensington lock slot to secure M-Track 2X2M
to a table or other surface.
Front Panel
1. Headphone Output: Connect 1/4"
(6.35 mm) TRS headphones to this
output. The mix you hear from this
output will be determined by the
USB / Direct Blend knob. The level
of this output is controlled by the
Headphone Level knob.
2. Instrument Inputs: Connect a guitar with a passive pickup or other high-impedance
signal to this input with a 1/4" (6.35 mm) TS cable. View the input signal levels with the
LED Meters.
Note: Using an Instrument Input will mute the Combo Input on the corresponding
channel.
3. +48V (Phantom Power) Switch: This switch activates and deactivates phantom power.
When activated, phantom power supplies +48 volts to the Combo Inputs. Please note
that most dynamic microphones and ribbon microphones do not require phantom power,
while most condenser microphones do. Consult your microphone's documentation to
find out whether it needs phantom power.
M -TRACK 2X2M
6
C -SERIES
1 5 4
2 2
MIC/LINE MIC/LINE
3 2
3 1
5