Publicité
Les langues disponibles
Les langues disponibles
You can also use any acid-free oil such as
sewing machine oil.
Note: The blades can be oiled with or without
comb attachment
11
Operation
Changing the attachments
Carefully place the desired comb attachment
onto the product as depicted in Fig. F. Ensure
that both recesses of the comb attachment
properly engage into the lateral detents at both
sides above the cutting unit
To remove the comb attachment
slide it forward and upwards using both thumbs,
as depicted in Fig. G.
Setting the trim length
To set different trim lengths, hold the upper
part of the product
part of the product
(0.8–2.0 mm). The set trim length will be displayed
on the length position indicator
with the dot-marking on the upper part of the
product
.
2
Trimming hair
Note: The hair being trimmed should be clean,
dry and untangled.
Carefully comb the hair using the supplied
comb
to disentangle any potential knots.
17
Place the hairdressing cape
neck and nape to prevent bits of hair from
falling into the collar.
Begin by using the longer comb attachment
and trim the hair gradually to the desired length.
Note that the desired trim length can only be
achieved if the product is held perpendicularly
to the skin's surface.
24 GB/IE
and thinning attachment
.
1
, press and
11
and twist the lower
2
into the desired position
5
which aligns
4
around the
15
Avoid making sudden movements when
trimming.
Switch the product on by pressing the ON / OFF
.
button
once. To maximize performance,
12
3 b
press the ON / OFF button
The Turbo display
if this is the case.
Switch the product off by pressing the ON / OFF
button
once or twice until the indicator light
3 b
goes off.
3 a
Activate the travel lock function by long pressing
11
the ON / OFF button
travel lock display
11
Deactivate the travel lock function by long pres-
sing the ON / OFF button
Then the product will switch on and the travel
lock display
Always trim from the nape in the direction of
the top of the head, or from the forehead and
temples towards the centre of the head.
Guide the product slowly and steadily through
the hair. If possible, trim against the direction
of the hair's growth.
While doing so, hold the product in such a
way that the selected comb attachment
positioned as level as possible.
Move the product over the head several times
to collect all of the hair. To achieve a straight
line, move the product through the hair several
times from different directions.
Comb the hair repeatedly.
You can graduate the desired trim length of the
comb attachment
ting the lower part of the product
to length position indicator
differ by 0.3 mm.
Example:
Comb attachment 3.0 mm
(trim length 3.8–5 mm):
Furthermost left
position (0.8 mm): short hair (3.8 mm)
11
Middle
position (1.4 mm): mid-length hair (4.4 mm)
Furthermost right
position (2.0 mm): long hair (5.0 mm)
one more time.
3 b
will appear on the display
8
3-5 seconds. Then
3 b
will light up.
9 a
3–5 seconds.
3 b
will go off.
9 a
more accurately by rota-
11
5
. These gradations
4
is
11
according
Publicité
