ENAR SPYDER PRO 2V 30 Manuel D'instructions page 27

5 LOCATING MALFUNCTIONS
With the open lid, check the light is on. Follow the table to identify the problem. During this operation follow
of the safety recommendations.
Make sure that the current is off during repairs.
4 CAPACITOR VERSION
5.1
PROBLEM
Not working, green led
(1) OFF
Red led (2) ON
Yellow led (3) ON
Blue led (4) ON
Led (2+3+4) ON
The poker is noisier
The vibrating poker
works correctly but it
overheats
FRECUENCY CONVERTER AND POKERS
See if it has power
Check cord
Check plug
Converter burnt out
Stator poker burnt out
Converter burnt out
Earth leakage current (check poker, connections)
Water inside converter or poker
Lack of phase in poker (3 phase motor). Check connections and cables
Overtemperature (check converter's cleanness and remove sticked
concrete and any unnecessary cover)
Bearings are not in good conditions.
Check the poker is not working out of concrete.
Verify the input voltage of the converter.
Bearings in bad conditions or without lubrication
2V 30, 2V 38, 2V 50, 2V 60, 2V 70, 1V 38, 1V 50, 1V 60
CAUSE
SPYDER PRO
en
11