ENAR SPYDER PRO 2V 30 Manuel D'instructions page 23

3.4 USE OF POWER TOOL
a) Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and off. Any power tool
that cannot be controlled with the switch is dangerous and must be repaired
c) Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
d) Store power tools out of the reach of children and do not allow people unfamiliar with the
power tool or these instructions to operate the power tool. Power tools are dangerous in the
hands of untrained users.
e) Look after your power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tools operation. If damaged,
have the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control;
g) Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could result in a hazardous situation.
3.5 SERVICE
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
3.6 SPECIFIC SAFE RULES
For the proper operation of the converter, MAKE SURE that operators have been instructed in the
proper management of this machine.
The converter SHOULD ONLY BE USED in the specific jobs.
Before connecting the converter to the electrical system, MAKE SURE that the voltage and frequency
coincide with the ones stated in the characteristics equipment name plate, located on the bottom of
the machine.
ENSURE that all box screws are tight before starting work.
Be sure that the parts of the poker are tight before starting work (welding points).
The plug should not be used to start or stop the equipment.
AVOID the flattening of the cable by heavy machinery which could cause breakage.
Keep the converter clean and dry.
Make sure that the electrical cable extension is with the proper section and functioning properly.
Before doing any work of maintenance, disconnect the motor from the electrical system.
FRECUENCY CONVERTER AND POKERS
2V 30, 2V 38, 2V 50, 2V 60, 2V 70, 1V 38, 1V 50, 1V 60
SPYDER PRO
en
7