ENAR SPYDER PRO 2V 30 Manuel D'instructions page 24

When connecting to a generator, make sure that the out tension and frequency is stable, right and has
the proper power. (the feeding voltage should not vary than +/- 10% as stated on the converter plate)
The level of acoustic pressure is less than 80 dB (see table point 2). Proper protective equipment
should be used.
The vibration that transmits to the operator does not exceed 2,5m/s
2.
The vibrating pokers should not be working out of concrete more than 5 minutes.
When finishing the job or when taking a break, the operator should switch off, disconnect it from the
electrical system, place it in a such way that should not fall or tip.
IN ADDITION, LOCAL COUNTRY STABLISHED ORDINANCES SHOULD BE RESPECTED.
4 OPERATION AND MAINTENANCE
GETTING STARTED
4.1
Read item 3 USAGE CONDITIONS
CONVERTER CONNECTION TO THE SYSTEM
4.2
The model SPYDER PRO 2V is connected to the main 230V +-5% / 50-60Hz (single phase) and the model
SPYDER PRO1V is connected to the main 115V / 50-60Hz (single phase).
en
Use a residual current device ("rcd") with a rated tripping current of 30mA for each converter. Rcd should be
installed either at the distribution board which feeds the mains supply sockets or at the fixed main supply
socket. Do not plug others electric tools to the rcd where is plugged the converter.
DISCONNECTING THE EQUIPMENT
4.3
Stop the converter by disconnecting the proper switch, and finally remove the plug from the main.
EARTH CONNECTION
4.4
To protect the user from an electrical shock, the converter should be correctly connected to earth.
The converters are equipped with three cables and their respective plugs. The adequate earth socket should
be used to connect the converters. If the socket with earth is not available, an earth adapter should be used
before connecting the plugs.
EXTENSION CABLES
4.5
Always use extension cables with earth wire and its respective plug with earth in the female and male plug.
Do not use damaged or worn out cables.
Avoid heavy loads on cables.
To determine the transversal section, follow the following procedure:
PROCEDURE TO DETERMINE THE NECESSARY TRANSVERSAL SECTION IN CABLE EXTENSION
8
SPYDER PRO
2V 30, 2V 38, 2V 50, 2V 60, 2V 70, 1V 38, 1V 50, 1V 60
2
of acceleration. See table in point
FRECUENCY CONVERTER AND POKERS