Publicité
Les langues disponibles
Les langues disponibles
Installation Guide (continued)
2. Secure the rear of the unit.
a) Check the electrical connection by referring to this operating instructions. (=> Page 23)
b) Connect Mounting Bolt ©, using a suitable wrench.
c) Insert Power Connector © to the unit.
d) insert the unit into Mounting Collar @ and push it in until a "click" is heard.
© Power Connector
Unit
Unit
(5) Mounting Bolt
e) Secure the rear of the unit to the car by either of the two recommended methods as follows.
e Using the Rear Support Strap ©
Fire Wall of Car
Affix one end of the Rear Support
Strap © to the rear of the unit, and
@Tapping Screw
3 mm
the other end to the fire wall of the
car, or some other metallic area.
@ Mounting Collar
e Using the Rubber Cushion
(Option)
(If there is an existing Rear Support
Bracket on the fire wall of the car.)
Cover the Mounting Bolt © on the
rear of the unit with Rubber Cushion
(Option), and mount it into the exist-
ing Rear Support Bracket.
Rear Support Bracket
(Existing on the car)
Rubber Cushion
(Option)
© Mounting Bolt
(© Mounting Collar
3. After installation reconnect the negative (—) battery terminal.
à
Publicité
