Panasonic CQ-R235U Manuel D'utilisation page 19

Antenna
Connect the antenna by plugging the antenna lead
into the antenna receptacle.
Equipment
Connect any optional equipment such as an amplifi-
er, according to the instructions furnished with the
equipment. Leave about 12 inches (30 cm) of dis-
tance between the speaker cords/amplifier unit and
the antenna/antenna extension cord. Read the oper-
ating and installation instructions of any equipment
you will connect to this unit.
Power
Connect the red power lead to the correct car radio
wire or to the appropriate fuse port on the fuse
block.
If the stereo unit functions properly with all these
connections made, disconnect the wires and pro-
ceed to the final installation.
1 Precautions
O Final Installation
Lead Connections
Connect all wires, making sure that each connection
is insulated and secure. Bundle all loose wires and
fasten them with tape so they won't fall down later.
Now insert the stereo unit into the mounting collar.
Congratulations! After making a few final checks,
you're ready to enjoy your new auto stereo system.
Q Final Checks
1. Make sure that all wires are properly connect-
ed and insulated.
2. Make sure that the stereo unit is securely held
in the mounting collar.
3. Turn on the ignition to check the unit for prop-
er operation.
If you have difficulties, consult your nearest autho-
rized professional installer for assistance.
e When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your
hands and fingers.
e We strongly recommend you to wear gloves for installation work to protect yourself from injuries.
J Installation Procedures
e Disconnect the cable from the negative (-) batt
1. Secure the Mounting Collar ().
Insert Mounting Collar (D into the dashboard, and
Dashboard
== > S
z
(D Mounting Collar S
ery terminal.
bend mounting tabs out with a screwdriver.
' +
#
isa
Lock Lever
Make sure that the
lock lever is flush
with the mounting
collar {not projecting
outward).
Screwdriver
CQ-R235U
19