Festo DG - GA Série Notice D'utilisation page 11

DGxx-...-GA
4 Fitting
S
Place the linear axis with sufficient free
space f against at least one of the front
sides.
Otherwise the cover section will prevent
access to the relevant positions when
maintenance is necessary.
This means that the axis would have to be
dismantled for maintenance purposes at a
later stage.
Size
f [mm]
Fig. 4
S Always place the guide rail 5 facing
upwards (see section "Technical specifica-
tions").
The slide has two identical surfaces to
enable you to do this.The guide rail offers
reliable protection against dirt from enter-
ing only when the DGxx-...-GA is used in
the horizontal position. The DGxx-...-GA
does not offer any protection against
whirled up particles of dirt.
S
Check to see if shock absorber supports
are required for strokes shorter than the
rated stroke.
Fitting shock absorber supports
S
Remove the cover section as follows:
– Clean the slide 4 and the cover sec-
tion 1 (see section "Care and mainten-
ance")
– Unscrew the fastening screws 3
– Remove the brush wiper 2
– Pull out the cover section 1
– Fit the KYP-... in accordance with the
operating instructions.
Festo DGxx-...-GA 0102NH English
18 25 32
87 105 131
Fig. 3
40 50 63
170 237 250
Fig. 5
Fig. 6
Fig. 7
5
11