Gram Scientific COMPACT 600 Mode D'emploi page 33

Electrical connection
Read the text below thoroughly before electrical connection.
Connect the detachable power cord to the main supply inlet, on the back of the controller
box (see fig. 5) where it is named "Electrical connection". Only the supplied cord is to be
used.
The power cord is found in the back of the top compartment, behind the label looking like
this:
The product is intended for connection to alternating current. The connection
voltage (V) and frequency (Hz) are shown on the name plate (see Fig.5).
Never use an extension cord for this appliance!
If a wall socket is placed in a longer distance than the length of the supplied power
cord, contact an electrician to establish a wall socket within the range of the
supplied power cord.
If the product is defective, it must be examined by a properly skilled technician
with proper knowledge of the product during the warranty period.
Outside the warranty period, it is advisable to use the service advised by your
dealer. If this is not the case, assistance is required from a properly skilled
technician with proper knowledge of the product.
Always disconnect the power if interruptions in power supply occur, and when electrical
parts are removed/put on, and before cleaning and maintenance of the product.
Repairing of electrical/technical parts may only be performed by properly skilled technicians
with proper knowledge of the product.
Do not use the product before all coverings are installed, so that live or rotating machine
parts cannot be touched.
The product is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be observed.
The plug and wall socket should then give correct earthing. If necessary, contact an
electrician.
Make sure the product is switched off at the socket before service is performed on
electrical parts. It is not sufficient to switch off the product by the START/STOP key
as there will still be voltage to some electrical parts of the product.
765042499 Rev. 001 33