Télécharger Imprimer la page

Magmaweld megaMIG 521M0200M0 Manuel D'utilisation page 26

Publicité

Les langues disponibles

Les langues disponibles

26
Maintenance and Service
MAINTENANCE AND SERVICE
EN
• Maintenance and repairs to the machine must be carried out by qualified persons. Magmaweld is not
responsible for accidents that may occur as a result of interventions by unauthorized persons.
• You can obtain the parts to be used in the repairs from our authorized services. The use of original spare parts
will extend the life of your machine and prevent performance losses.
• Always contact Magmaweld or an authorized service specified by Magmaweld.
• All warranty provisions will become void due to any interference not authorized by Magmaweld within the
warranty period.
• Make sure you comply with the applicable safety rules during maintenance and repair works.
• Disconnect the machine's plugs from the mains before carrying out any repairs and wait for 10 seconds for
the capacitors to discharge.
4.1 Maintenance
Every 3 Months
• Do not remove the warning labels on the device. Replace worn/torn labels with new
ones. You can obtain the labels from the authorized service.
• Check your pliers and cables. Pay attention to the connections and soundness of the
parts.
• Replace damaged / defective parts with new ones. Never add/repair cables.
• Make sure there is enough space for ventilation.
Every 6 Months
• Clean and tighten the connecting parts such as bolts and nuts.
• Check the electrode holder and ground clamp cables.
• Open the side covers of the machine and clean it with low pressure dry air.
• Do not apply compressed air from close distance to electronic components.
4.2 Non-Periodic Maintenance
• Wire Feeding Mechanism should be kept clean and roller surfaces should never be greased.
Residues accumulated on the mechanism should always be cleaned by dry air at every welding wire change.
• The consumables on the torch should be cleaned regularly.
If necessary, they should be replaced. Make sure that these materials are original products for ensuring
long-term use.
NOTE: The above mentioned periods are the maximum ones that should be applied if no problems are
encountered in your device. Depending on the work load and contamination of your work environment,
you can repeat the above processes more frequently.
Never operate the machine when covers are open.
USER MANUAL
megaMIG
or
www.magmaweld.com

Publicité

loading