Programming Via The Dmx-Controller; Functions Of The Control Channels - Futurelight AS-200 Advertising Scan Mode D'emploi

Connect the controller with the projector using a stereo shielded cable and 3-pin XLR-connectors.
In order to connect the controller, you have to adjust the starting address of the AS-200 via the mode „Setting the
DMX starting address". Please refer to the explanations under „Setup".

5.2 Programming via the DMX-controller

After you switched the device on, you have to carry out a reset. In order to do so, adjust control channel 6 to the
DMX-value 244-247 and the lamp will trigger. The display shows „DMX" and the scanner is ready for use. Now
you can adjust the settings via your DMX-controller.
The programmed settings are externally stored in your controller. In addition to the externally stored settings,
you can call up the 10 internal programs via your controller (control channel 6).
Additional functions via DMX
Your Advertising Scan offers the possibility to control some additional functions via DMX. These functions can
be found in the table „Channel 6: Dimmer/Shutter/Strobe".
Enable external DMX-control
If operational periods have been programmed and the programmed sequence is run through, you have the
opportunity to cancel the program-run and to control the device manually.
How to proceed:
Set channel 6 to the DMX-values 244-247. The scanner will reset and the display shows „DMX" and „RESET".
Remark: Adjust channel 6 to a different DMX-value in order to avoid that the device will continuously
reset.
After the device has finished the reset, it can be controlled via the controller.
Disable external DMX-control
Set channel 6 to the DMX-values 248 - 249. The display shows „DMX" and „OFF". The device will change to
red and the shutter is half-open.
The device will start the sequence, if the operating period is still ON. Otherwise, the device will go into blackout-
mode.
Switching off the lamp
In order to protect the lamp, you can switch it off with this function. Set channel 6 to the DMX-values 250 - 251.

5.3 Functions of the control channels

Channel 1: Pan-movements:
Adjust the settings in order to move mirror horizontally (PAN) or vertically (TILT).
Gradual mirror movements by slow adjustment of the settings (0-255; 128 = center).
The mirror can be stopped at any position you wish.
Channel 3: Not occupied
Channel 2: Tilt-movements:
31