Futurelight AS-200 Advertising Scan Mode D'emploi page 25

Starting the test-program:
With this function, you can start the projector's self-test-program. If you run the test-program regularly, you can
be sure that all functions will be available and that the motors run correctly.
Press the Mode-button.
Press the Up-button until the display shows „TEST".
Press the Enter-button. „TEST" flashes in the display.
The self-test-program is executed.
Press the Mode-button in order to cancel the test-program.
Inverting the PAN/TILT-movement:
This function is only needed for external control via a DMX-controller.
With this function, you can increase the attractivity of the projections of several projectors even more. Further-
more, this function makes the programming much easier. For example, you can invert the PAN-movement of
projectors, which have been installed on opposite sides, so that the light beams will cross.
Press the Mode-button.
Press the Up-button until the display shows „RPAN" or „RTLT", respectively.
Press the Enter-button. The display shows „NO".
Invert the movement by adjusting „YES" via the Up/Down-buttons.
Press the Enter-button.
Activate the sound-control:
Your Advertising Scan can also be run sound-controlled via the built-in microphone. In this mode, the speed of
changing from step to step is controlled by the bass-beat of the music.
Press the Mode-button.
Press the Up-button until the display shows „SND".
Press the Enter-button. The display shows „NO".
Activate the sound-control by adjusting „YES" via the Up/Down-buttons.
Press the Enter-button.
Remark: You can adjust the microphone sensitivity via the sensitivity-control and a screwdriver.
Adjusting the time/weekday:
Press the Mode-button.
Press the Up-button until the display shows the time. When you adjust the time for the first time, the display
shows 00.00.
Press the Enter-button.
Adjust the hours via the Up/Down-buttons (0-23 h).
Press the Enter-button.
Adjust the minutes via the Up/Down-buttons.
Press the Enter-button.
Adjust the via the Up/Down-buttons.
Press the Enter-button.
Adjusting the operating periods:
If the projector is to be controlled externally via a DMX-controller, this function is not needed. If operating periods
have been adjusted, these are to be deleted. Please refer to the section „Delete the programmed operation
periods".
Press the Mode-button.
Press the Up-button until the display shows „ONOF".
Adjusting the starting time:
Press the Enter-button.
The display shows „Mo.On". Now you can adjust the starting time for Monday. If you wish to select a different
weekday, press the Up/Down-buttons until the display shows the desired weekday and „On".
Press the Enter-button.
Adjust the hour via the Up/Down-buttons.
Press the Enter-button.
Adjust the minutes via the Up/Down-buttons.
Press the Enter-button.
25